Panasonic PT-RW930 - [Shutter Setting]

Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 115
[SHUTTER SETTING]
Set the operation of the shutter function.
Setting [FADE-IN] or [FADE-OUT]
Set the image fade-in and fade-out when the shutter function operates.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [FADE-IN] or [FADE-OUT].
4) Press qw to switch the item.
Item Adjustment
[FADE-IN]
[FADE-OUT]
[OFF] Does not set fade-in or fade-out.
[0.5s] - [10.0s]
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/open) when the power is turned on.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
4) Press qw to switch the item.
[OPEN]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
[CLOSE]
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
Setting the shutter synchronization function
The shutter synchronization function is a function to synchronize the shutter operation of the specied projector
to other projectors, and the effect using the shutter function including the fade out/fade in operation can be
synchronized.
To use the shutter synchronization function, it is necessary to connect the projectors targeted for synchronization
in a loop with daisy chain connection using the <SERIAL/MULTI PROJECTOR SYNC IN> terminal and the
<SERIAL/MULTI PROJECTOR SYNC OUT> terminal. For details of how to connect the projectors, refer to
“Connecting example when using the contrast synchronization function/shutter synchronization function”
(x page 54).
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [MULTI PROJECTOR SYNC].
4) Press the <ENTER> button.
f The [MULTI PROJECTOR SYNC] screen is displayed.
5) Press as to select [MODE].