Chapter 4 Settings — [PROJECTOR SETUP] menu
140 - ENGLISH
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4) Press as to select an item to initialize.
[ALL USER DATA]
Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGO
IMAGE] to the factory default settings.
The projector enters the standby mode to reect the setting values.
[REGISTERED SIGNAL]
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in “Deleting the
registered signal” (x page 144).
[NETWORK/E-MAIL]
Returns the setting of the [NETWORK] menu → [NETWORK SETUP] and the setting of “[E-mail set
up] page” (x page 168) in the web control screen to the factory default settings.
[LOGO IMAGE] Deletes the image registered in [USER LOGO].
5) Press the <ENTER> button.
6) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
f The following settings are not initialized even if [ALL USER DATA] is executed.
g The [DISPLAY OPTION] menu → [UNIFORMITY]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE]
g The [PROJECTOR SETUP] menu → [OPERATION SETTING] → [MAX LIGHT OUTPUT LEVEL]
g The [PROJECTOR SETUP] menu → [STANDBY MODE]
[SERVICE PASSWORD]
This function is used by a service person.
To Next Page
Loading...
