Panasonic PT-RW930 - Page 65

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 65
2) Press as to select [SCREEN POSITION].
f [SCREEN POSITION] cannot be selected or adjusted when [SCREEN FORMAT] is set to [16:10] in
PT-RZ970 or PT-RW930, or when [SCREEN FORMAT] is set to [4:3] in PT-RX110.
16:9
0
5/7
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGE
SCREEN FORMAT
ENTER
MENU SELECT
3) Press qw to adjust.
4) Press the <ENTER> button to proceed to the initial setting.
Initial setting (time zone)
Set [TIME ZONE] in accordance with the country or region where you use the projector.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [DATE
AND TIME]. The current settings are displayed in [LOCAL DATE] and [LOCAL TIME].
1) Press qw to switch the setting.
+09:00
6/7
20XX/01/01
12 : 34 : 56
LOCAL DATE
LOCAL TIME
Please set up a time zone according to the area of your
country or region.
INITIAL SETTING
SET
CHANGEMENU SELECT
TIME ZONE
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Note
f In the factory default setting, the time zone of the projector is set to +09:00 (Japan and Korea Standard Time). Change the setting of the
[PROJECTOR SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.