60
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Running the PHOTOVU/
MPGE4 Movie Messenger™
System*
Before you begin
• Insert a recorded tape. (p. 11)
* PHOTOVU: You can transfer Still images
from your Palmcorder tape to a PC.
MPEG4 Movie Messenger™ System:
You can transfer Motion images from your
Palmcorder tape to a PC.
1Set Palmcorder POWER to VCR.
2Connect the Palmcorder to your PC
using the USB Cable (supplied) or
DV interface Cable (i.LINK) (not
supplied). (pp. 58, 59, 72)
3Click on “Start,” “(All) Programs,”
“Panasonic,” “MPEG4
MovieMessenger System 1.00,” then
“MovieMessenger.”
4“PHOTOVU/MPEG4 MovieMessenger
System 1.00” is opened.
Refer to Help for information about
application operations and Error
messages.
ASet Palmcorder POWER to VCR.
BConnect the Palmcorder to your PC
using the USB Cable (supplied) or
DV interface Cable (i.LINK).
CStart up the PHOTOVU/MPEG4
Movie Messenger™ System.
While PHOTOVU/MPEG4 Movie Messenger™ System is running,
do not perform the following operations...
The PC system may become unstable.
• Change the screen area or color pallet in the Display Properties window.
• Turn the Palmcorder power switch ON or OFF while connecting the Palmcorder to your
PC using the USB Cable or DV Interface Cable (i.LINK).
• Change the Palmcorder power switch (VCR/CAMERA).
*You must first close the application.
• Connect/disconnect the DV Interface Cable (i.LINK).
• Connect/disconnect the USB Cable.
How to insert the USB Cable or
DV Interface Cable (i.LINK)
AClose the PHOTOVU/MPEG4 Movie
Messenger™ System.
BRemove the USB Cable or DV
Interface Cable (i.LINK) from the
Palmcorder.
CSet Palmcorder POWER to OFF.
How to remove the USB Cable
or DV Interface Cable (i.LINK)
Note
PHOTOVU/MPEG4 Movie Messenger™ System
PV-DV52 / PV-DV52-S / PV-DV102 / PV-DV202 / PV-DV402
64
To Next Page
Loading...
