Panasonic PV-DV202 - PC Connection; Transferring Your Images (Macintosh)

90
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
Transferring Your Images (Macintosh)
You can transfer images from your Palmcorder tape to your Macintosh.
• Mac OS 9.0~9.1
• Mac OS 8.6~9.1 (for ArcSoft Software)
• iMac, iBook or Power Macintosh
®
G3 with
USB port or Power Mac
™
G4
• RAM: 64 MB or more
• CD-ROM drive (for installation)
System Requirements
(for Built-in SD Drive/ArcSoft Software)
• USB Port
• Mouse or other pointing device
• 210 MB minimum available hard disk
space (for ArcSoft Software)
• High color (16 bit) or more (for ArcSoft
Software)
* Even if system requirements are met, there is no guarantee that the included software
will work on all personal computers.
Connection
3
2
USB Terminal
USB Terminal
1Turn on your PC.
2Set the Palmcorder POWER to M-CARD.
3Connect the Palmcorder to your Macintosh using the USB Cable (supplied).
• For extended use, it is recommended to use the AC Adaptor as a power source.
USB Cable
(supplied)
Note
PV-DV52 / PV-DV52-S / PV-DV102 / PV-DV202 / PV-DV402
94