9.4. Electrical Adjustment Procedures
9.4.1. Initial guideline
The table below shows which adjustments are necessary according to the unit parts and individual parts to be replaced.
Make sure to perform these adjustments shown below as necessary.
9.4.2. Set-up manual for Digital Video Camcorder or Digital Video Camera.
1. Installation of USB-SERIAL Driver
Execute the “Setup.exe” file in “Com Mass” folder by double clicking to install the USB-SERIAL driver.
2. Set-Up
a. Remove the tape from this unit.
b. To enter the PC connection (COM) mode, push the [PHOTO SHOT] button, [RECORDING START/STOP] button and
[MANUAL AF/MF] simultaneously for 3 seconds without connecting the USB Cable.
31
PV-GS90P
To Next Page
Loading...
