Panasonic PV-L751 - Page 17

17
Basic Operation
Before you begin...
• Connect Camcorder to power source.
• Insert cassette with record tab (page 11).
Camera Recording
SELECTSELECT : PUSH: PUSH / KEYKEY
SETSET : PUSH : PUSH DIDISPLAY KEYSPLAY KEY
ENDEND : PUSH MENU KEY: PUSH MENU KEY
--- MENU MENU --- PAGE PAGE 1/21/2
PROGRAMMED RECPROGRAMMED REC
TITITLETLE ; ; AUTO/MANUALAUTO/MANUAL
SHUTTERSHUTTER ; ; AUTOAUTO
STAND-BY RELEASESTAND-BY RELEASE ; OFF ; OFF
CLOCK SETCLOCK SET
1Set POWER to CAMERA.
2Press MENU for
MENU mode.
Press
UP or
DOWN to
select
STAND-BY RELEASE .
3Press DISPLAY to select ON/OFF.
ON : From Stand-by mode, press
RECORD/PAUSE two times
to resume recording.
OFF : From Stand-by mode,
set
POWER to OFF, then to
CAMERA. Press RECORD/
PAUSE to record.
4Press MENU to exit.
Stand-by Quick Release
If left in RECORD/PAUSE mode for 5
minutes, Camcorder switches to Stand-
by mode to conserve battery. When set
to ON, Stand-by Quick Release lets
you resume recording by pressing
RECORD/PAUSE two times. Stand-by
Quick Release is set to OFF at the
factory.
aPress RECORD/PAUSE to stop
recording.
bSet POWER to OFF and leave cassette
in Camcorder.
cTo resume recording, set POWER to
CAMERA.
dPress RECORD/PAUSE to resume
recording.
Note:
• Use Manual Easy Edit (left) if more than
24 hours before recording is resumed.
Manual Easy Editing
For a smooth transition between scenes if
recording is stopped, and then started
within 24 hours.
For proper continuity when taping from Stop
mode or after attaching a new Battery.
Easy Edit Stand-by
ASet POWER to VCR.
Ba Press REWIND/SEARCH to rewind
a few seconds of tape.
B b Press PLAY to review recording.
C c Press STILL where you want to
continue recording.
CSet POWER to CAMERA.
DPress RECORD/PAUSE to resume
recording.
B
2, 3, 4
MENU
UP
DOWNDOWN
DISPLAY
FOCUS
FAR
NEAR
CAMERACAMERA
OFFOFF
VCR
PHOTOPHOTO
STOP
STILL
PLAY
REW
FF
+
DEL
c
b
a
a, d,
D
1,
b, c,
A , C