Panasonic RF-D20BT

12
TQBJ2029
Bluetooth
®
You can connect and play an audio
device wirelessly through Bluetooth
®
.
Preparation
• Switch on the Bluetooth
®
feature of
the device and put the device near
the system.
• Read the operating instructions of
the device for details.
Pairing a device
Preparation
If this system is connected to a
Bluetooth
®
device, disconnect it
(Z“Disconnecting a device”).
1 Press and hold [ ].
If “Pairing” is shown, continue with
step 5.
2 Press [MENU].
3 Press [ TUNE/SELECT ] to
select “Pairing” and then press
[ENTER].
4 Press [ TUNE/SELECT ] to
select “Yes” and then press
[ENTER].
“Pairing” is shown.
To cancel, select “No”.
5 Select “RF-D20BT” from the
Bluetooth
®
menu of the device.
If prompted for a passkey, input
“0000” or “1234”.
The device connects with this
system automatically after pairing is
complete.
Note:
You can pair up to 8 devices with this
system. If a 9th device is paired, the
device that has not been used for the
longest time will be replaced.
Connecting a device
Preparation
If this system is connected to a
Bluetooth
®
device, disconnect it
(Z“Disconnecting a device”).
1 Press [ ].
“Bluetooth Ready” is shown.
2 Select “RF-D20BT” from the
Bluetooth
®
menu of the device.
3 Start playback on the device.
Press [4/9] to pause or resume the
playback.
Note:
• A device must be paired to connect.
• This system can only connect to one
device at a time.
• When “Bluetooth” is selected as the
source, this system will automatically try
to connect to the last connected device.
Disconnecting a device
While a Bluetooth
®
device is
connected
1 Press [MENU].
2 Press [ TUNE/SELECT ] to
select “Disconnect” and then
press [ENTER].
3 Press [ TUNE/SELECT ] to
select “Yes” and then press
[ENTER].
“Bluetooth Ready” is shown.
To cancel, select “No”.
Alternatively, press and hold [ ] until
“Pairing” is shown to disconnect the
device.
D20BT_en.fm Page 12 Wednesday, December 28, 2016 2:55 PM
offset printing