9
TQBJ2029
Getting started
1 Extend the antenna.
2 Press [1] to switch on the unit.
The first time you switch on the unit, it
will enter DAB mode and automatically
scan for stations. It sets the time and
date (if data is available) and starts
playing the first station it finds.
Note:
In standby mode, the unit shows the time
and date (only when the unit is powered by
AC).
DAB/DAB+
DAB (Digital Audio Broadcasting) is a
procedure of broadcasting the radio
digitally. It gives less interference and
better sound quality.
This unit supports DAB in “BAND III”
bands.
DAB operation
The first time you enter DAB mode, or if
the station list is empty, the unit will
start the full scan and memorise the
stations.
You can perform the full scan
procedure when there is a new station
or a station becomes available.
1 Press [SOURCE] to select “DAB”.
2 Press [MENU] to select “Full scan”
and then press [ENTER] to start
full scan.
To cancel, press [MENU].
█ Remove unavailable listed
stations
This unit indicates those stations that
are closed or no longer available with a
question mark in front of the station
name. You can remove these stations
from the station list.
1 Press [MENU] and then press
[ TUNE/SELECT ] to select
“Prune”.
2 Press [ENTER].
3 Press [ TUNE/SELECT ] to
select “Yes” and then press
[ENTER].
To cancel, select “No”.
D20BT_en.fm Page 9 Wednesday, December 28, 2016 2:55 PM
To Next Page
Loading...
