VQT5C48
12
12
Making a phone call
With Bluetooth
®
enabled phones (cell phones or smartphones) that support the
“HFP” or “HSP” Bluetooth
®
profile, you can use the headset for phone calls.
• HFP (Hands-Free Profile):
In addition to the HSP function, an advanced communication feature is
available.
• HSP (Headset Profile):
Hands-free phone calls are possible using the headset.
When answering an incoming call
When making an outgoing call
1
Connect the Bluetooth
®
enabled phone and headset ( P. 8)
2
Press the Call button
on the headset and answer
the call
• During an incoming call, one
short continuous ringtone will
sound from the speaker and the
LED will blink.
•(HFP only) To reject the
incoming call, press and hold
the Call button
until the
ringtone stops.
Make an outgoing call on
the Bluetooth
®
enabled
phone
• Also refer to the operating
manual for the Bluetooth
®
enabled phone.
(Checking and operation steps on the
headset are explained below)
• During an outgoing call, the
ringtone (two-tone beep) will
sound from the speaker and the
LED will blink.
• To cancel the outgoing call,
press the Call button
.
One short beep will sound.
•(HFP only) When the phone
is idle, press and hold the Call
button
for approximately 2
seconds. An outgoing call will be
made to the last dialed number.
One short continuous ringtone
will sound from the speaker and
the LED will blink.
3
Start talking
• The LED will repeatedly blink 3 times during a call.
• The volume can be adjusted during a phone call. For setting
instructions, see page 11.
4
Press the Call button to end the phone call
• One short beep will sound.
Call
Microphone
Left (outside) Left (inside)
To Next Page
Loading...
