6
ENGLISH
ENGLISH
RQT6634
3
4
6
7
L
R
OPR/CHG
OPR
OFF ON
TUNING
MIN
MAX
VOL
MIN
MAX
VOL
MIN
MAX
VOL
OPR
OFF ON
TUNING
1
Operation
…
1
Extend the rod antenna.
…
2
Turn on the unit the transmitter is
connected to.
…
3
Reduce the volume of the head-
phones with the [VOL] dial.
…
4
Switch the [OPR] switch to “ON”.
The OPR/CHG lamp goes red.
Put the headphones on.
…
5
Turn the volume on the sound
source up as much as possible with-
out causing distortion.
…
6
Adjust the volume on the head-
phones.
…
7
If there is interference, turn the
[TUNING] dial to reduce it.
See page 7 for more detailed instructions on how
to reduce interference.
After listening
∆∆
∆∆
∆
1 Take the headphones off.
∆∆
∆∆
∆
2 Switch the [OPR] switch to “OFF”.
The OPR/CHG lamp goes out.
∆∆
∆∆
∆
3 Turn off the unit the transmitter is connected to.
Note
¡Avoid listening for prolonged periods of time to prevent
hearing damage.
¡Discontinue use if you experience discomfort with the
headphones that directly contact your skin.
Continued use may cause rashes or other allergic reac-
tions.
Concerning the AUTO POWER ON/OFF
function:
When audio signals are supplied, the transmitter’s power
is turned on (The OPR lamp lights.); when audio signals
have not been supplied for 2 or 3 minutes, its power is
automatically turned off. (The OPR lamp goes out.)
When the volume of the connected unit is too low, this
function doesn’t work. Turn up the volume as much as
possible without causing distortion.
To Next Page
Loading...
