7. Self-Diagnostic Functions
7.1. Setting of the Self-Diagnostic Mode
1. Switch the SELECTOR to CD and set to TAPE STOP state. (CD PLAY STOP)
2. Press the /CLEAR for the first two seconds and followed by the FAST
FORWARD keys for another two seconds without releasing the /CLEAR key, it
shall enter into the Self-Diagnostic mode.
3. At the state of [ T ] display, operate as follows:
- Open the CD lid and close it right away.
- Start recording TAPE, and STOP it at once.
4. Press /CLEAR key.
- Self diagnostic results, i.e. the memorized errors during actual operations
and the result of above-mentioned operation shall be displayed alternately.
- If there is no error, the aforementioned display [ T ], shall be kept.
- If the operation in the above mentioned in 4 is made without executing the
procedure in 3, [ H16 ] and [ F69 ] shall be displayed.
7.2. Display Location
10
To Next Page
Loading...
