Panasonic RX-D10 - Disassembly Procedures

1. This section describes procedures for checking the operation of the major
printed circuit boards and replacing the main components.
2. For reassembly after operation checks or replacement, reverse the respective
procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are required.
4. Refer the Parts No. on the page of “Main component Replacement Procedures”, if
necessary.
Content
- Disassembly Procedure for each major P.C.B.
1. ing for the Main, Panel1, Panel2 & Speaker Terminal P.C.B
........................................................................ P.g. 7 ~ 8
2. Checking for the CD Servo P.C.B
..................................................................................................................................
P.g. 8
- Main Component Replacement Procedures
1. Replacement of the Traverse Deck
..............................................................................................................................
P.g.9
2. Installation of the CD Servo P.C.B. after Replacement
................................................................................................ P.g.10
Warning:
This product uses a laser diode. Refer to
.
8.1. Disassembly Procedure for each major P.C.B.
8.1.1. Checking for the Main, Panel1, Panel2 & Speaker Terminal P.C.B
12