Basic play
Use normal position tapes.
High position and metal position tapes can be played, but
the unit will not be able to identify the characteristics of these
tapes.
1 Press [TAPE/OFF].
2 Open the cassette operation buttons’ lid.
3 Press [8/x, STOP/EJECT] and insert the cassette.
Insert with the side to be played facing up and the exposed
tape facing towards you. Close the deck by hand.
4 Press [4, PLAY] to start play.
Stop tape
playback
Press [8/x, STOP/EJECT].
Pause play
Press [9, PAUSE].
Press again to resume play.
Fast-
forward and
rewind
Press [3, REW/REV] or [5, FF/CUE] in
the stop mode.
Search for
a specifi c
point
Press [3, REW/REV] (to search backward)
or [5, FF/CUE] (to search forward) during
playback.
Play is resumed when the button is released.
Recording
Use normal position tapes.
High position and metal position tapes can be used, but the
unit will not be able to record or erase them correctly.
✒
Preparation
Wind up the source tape so recording can begin immediately.
1 Press [0, STOP/EJECT] and insert the cassette to
be recorded.
Insert with the side to be recorded facing up and the
exposed tape facing towards you.
2 Select the source to be recorded.
Radio
Tune in the station (Z page 7).
Disc
1. Insert the disc you want to record.
Press [4/9, CD] and then [8] (stop).
2. Prepare the desired disc recording mode.
Record programmed tracks
Program the tracks you want (Z page 6).
Record specifi c albums or tracks
Press [PLAY MODE] to select the desired
mode (Z page 6).
Music port
Select music port (Z page 10).
3 Press [
V
] to start recording.
Stop recording
Press [8/x, STOP/EJECT].
Record on the
other side of
the tape
Turn the cassette over and press [
V
].
Erase a
recorded
sound
1. Press [TAPE/OFF].
2. Insert the recorded cassette.
3. Press [
V
].
Your attention is drawn to the fact that recording pre-
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
✒
Note
Changes to volume and sound quality do not affect recording.
Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for Side ATab for Side B
To prevent recording
Adhesive tape
To re-record
✒
Note
• Tapes exceeding 100 minutes are thin and can break or get
caught in the mechanism.
• Tape slack can get caught up in the mechanism and should
be wound up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts
if used incorrectly.
RQTX1148-1B_gb.indd 8RQTX1148-1B_gb.indd 8 3/30/2010 10:21:33 AM3/30/2010 10:21:33 AM
To Next Page
Loading...
