Panasonic RX-D50 - Clock and Timer Features; Setting and Displaying the Clock; Play Timer Functionality; Sleep Timer Functionality

9
RQTX1148
Change the
settings
Repeat steps 1 to 4 and 6 (Z see left).
Change the
source or
volume
1. Press [# PLAY] to clear the timer
indicator from the display.
2. Make changes to the source or volume.
3. Perform steps 5 and 6 (Z see left).
Check the
settings
(when the
unit is on or in
standby mode)
Press [CLOCK/TIMER] repeatedly to
select # PLAY (there is no display when
the unit is powered by batteries and is in
standby mode).
Cancel
Press [# PLAY] to clear the timer indicator
from the display.
✒
Note
• The play timer will start at the preset time, with the volume
increasing gradually to the preset level.
• The timer comes on at the set time every day if the timer is
on.
• The unit must be in the standby mode for the timer to
function.
• If you turn the unit off and on again while a timer is
functioning, the fi nish time setting will not be activated.
Using the sleep timer
Using the sleep timer
This function enables you to turn off the unit automatically after
the set time except in tape mode.
Press [SLEEP] repeatedly to select your desired time
(in minutes).
To cancel
Press [SLEEP] repeatedly to select “OFF”.
Changing the remaining time
Press [SLEEP] to show the remaining time, and press [SLEEP]
again to select your desired time.
✒
Note
• The play and sleep timer can be used together.
• The sleep timer always has priority. Be sure not to overlap
timer settings.
Using the clock and timers
Setting the clock
Setting the clock
This is a 24-hour clock.
1 Press [CLOCK/TIMER].
Each time you press the button:
Original display
# PLAY ON
CLOCK
2 Within 5 seconds or so
Press [2/3] or [5/6] to set the time.
Holding down the button will speed up the time selection.
3 Press [CLOCK/TIMER] to fi nish setting the time.
Displaying the clock
Press [CLOCK/TIMER] to display the clock for few seconds.
✒
Note
• Reset the clock regularly to maintain accuracy.
• When the unit is in standby mode and it is powered by
batteries, clock will not be displayed.
Using the play timer
Using the play timer
You can set the timer to come on at a certain time to wake you
up.
✒
Preparation
• Turn the unit on and set the clock.
• Prepare the music source you want to listen to; disc, radio or
music port source, and set the volume.
1 Press [CLOCK/TIMER] repeatedly to select the play
timer.
2 Within 5 seconds or so
Press [2/3] or [5/6] to set the starting time.
3 Press [CLOCK/TIMER] to confi rm.
4 Repeat steps 2 and 3 to set the fi nishing time.
To activate the timer
5 Press [# PLAY] to turn on the timer.
# PLAY
No display (off)
6 Press [TAPE/OFF] to turn off the unit.
RQTX1148-1B_gb.indd 9RQTX1148-1B_gb.indd 9 3/30/2010 10:21:33 AM3/30/2010 10:21:33 AM