11
4 Specifications
I Amplifier Section
RMS output power stereo mode
Front Ch (both channels
driven)
3 W per channel (4 Ω), 1 kHz, 10%
THD
Total RMS stereo mode power 6 W
I FM/AM Tuner, Terminal Section
Frequency Modulation (FM)
Frequency range 87.50 MHz to 108.00 MHz (50 kHz
step)
Amplitude Modulation (AM)
Frequency range 522 kHz to 1629 kHz (9 kHz step)
520 kHz to 1630 kHz (10 kHz step)
Headphone jack
Terminal Stereo, 3.5 mm jack (32 Ω)
Music port (front) jack
Sensitivity 100 mV, 4.7 kΩ
Terminal Stereo, 3.5 mm jack
I Disc Section
Disc played (8 cm or 12 cm)
(1) CD-Audio (CD-DA)
(2) CD-R/RW (CD-DA, MP3* formatted disc)
(3) MP3*
* MPEG-1 Layer 3, MPEG-2 Layer 3
Bit rate
MP3 32 kbps to 320 kbps
Sampling frequency
CD 44.1 kHz
MP3 32 kHz, 44.1 kHz, 48 kHz
Decoding 16 bit linear
Beam source Semiconductor laser (wavelength
795 nm (CD))
Frequency response 40 Hz to 20kHz
Number of channels 2 channel, stereo
Wow and flutter Less than possible measurement
data
I Cassette Deck Section
Track system 4 track, 2 channel, stereo
Monitor system Variable sound monitor
Recording system AC bias 84 kHz
Erase system Multi pole magnet
Overall frequency response
NORMAL 50 Hz to 12 kHz
I Speaker Section
Speakers Impedance 4 Ω
Full range 2 x 8 cm
Ceramic tweeter 2 x 1.5 cm
I General
Power supply
AC 230 V, 50 Hz
Battery 12 V (8 x LR14, C)
Memory back-up 6 V (4 x R6/LR6, AA)
Power consumption 14 W
Battery life (use only alkaline batteries)
Radio broadcast 9 hours
Radio recording 9 hours
CD playback 6 hours
CD recording 7 hours
Tape playback 8 hours
Dimensions (W x H x D) 408 mm x 148 mm x 271 mm
Mass 3.3 kg without batteries (3.9 kg with
batteries)
Operating temperature range 0
°C to +40°C
Operating humidity range 35% to 80 % RH (no condensation)
Power consumption in standby mode: 0.8 W (approximate)
Notes :
1. Specifications are subject to change without notices.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by the digital spectrum ana-
lyzer.
To Next Page
Loading...
