Panasonic RX-ED707 - Before Recording (Only Deck 2)

Recording a
RQT4598
Leader tape (on which nothing can be recorded)
| Before Recording (Only Deck 2) |
recording
Automatically identifies the type of tape.
Normal position/TYPE | CE
High position/TYPE tl TED
Metal position/TYPE IV
This unit cannot make a recording or erase correctly if metal position
tapes are used.
To record from the beginning of the tape F
You cannot record on the leader part of the tape. Before recording,
wind the tape past the leader to a point where recording can start
immediately.
®© Load the tape in deck 2.
@ Press [E TAPE/CD) to select “TAPE”.
@ Press [@/@ If REC/REC PAUSE}.
eYou cannot operate deck 1 during recording.
“E” is displayed when you attempt to operate deck 1.
e Any change made to the volume or sound quality during recording
will not affect the recording.
ein order to prevent trouble caused by flat batteries, it is recom-
mended that you either supply power to the unit from the house-
hold AC outlet or replace all the batteries with new ones when you
are recording something which is important to you.
The recording level is set automatically.
e“E” is displayed if the cassette you are using has had its tabs re-
moved. (œ page 28)