Panasonic RX-ED707 - Page 21

| Recording from CDs |
One track recording (1 TRACK)
Records one track from the CD and stops. This function is con-
venient when recording different tracks from various CDs.
Recording can begin from any place on the tape.
Getting ready: insert a CD.
i Press [4 DECK 2] and load the cassette with
the side to be recorded facing up.
Recording direction is automatically set to begin from the side
facing up (the “œ>” indicator is displayed).
Find the position on the tape where recording is to begin.
2| Press [M TAPE/CD] to select the CD mode.
3 Press [CD REC MODE] to display “1-REC”.
AUTO 1-REC—> OFF
to. —
{The display changes each time the button is pressed.)
Press [A/»»1] or [V/H@«]to Select the track to |
be recorded.
Omit this step when recording the first track on the CD.
Press [@/@ 11 REC/REC PAUSE].
CD play and recording begin simultaneously. Records only one
track and stops.
Reverse mode is displayed as “522”.
eif the track is interrupted when the end of the cassette is
reached, recording automatically begins again from the be-
ginning of the track on the opposite side (if recording was be-
gun on the opposite side, recording stops at the end of the
present side).
To continue recording with another CD:
Press [4 CD OPEN/CLOSE], insert a CD and follow steps EJ and
5B.
To stop recording (CD will also stop):
Press [E TAPE/CD].
Try listening to the track to check the type of song it is before record-
ing. Press [CD REC MODE] to display “1-REC,” then [18 CD] to
play the CD.
Press [@/@ Il REC/REC PAUSE] to record a song you like during
CD play. The track is recorded from the beginning.
Guip1020y im