Panasonic RX-S35 - Location of Controls and Components; Component Identification; Disassembly Instructions; General Disassembly Steps

LOCATION OF CONTROLS AND COMPONENTS
1) arta Indicator @ *Dolby Noise Reduction
Switch (DOLBY NR)
5 @ Headphones Jack [IN, OUT]
(PHONES) $3.5, 322 @ Tape Direction Buttons
s © Volume Control (REV &- FWD Vv)
= 12 (VOLUME) @ Tape Selector (TAPE)
ais =e, © Band Selector [NOR, CrO,/METAL]
Mis OF) © Battery Check Indicator @ pjayback Button
; ua (BATT) A PLAY V
a: i | . @ Function Selector ® aidan. Couiae
Ry (TAPE/OFF, RADIO] Buttons (4 -J)
QO; ff Rae @ Tuning Control (Tuning) .
RK @ Clip Receptacle
y E 8 pA Ape @ Battery Compartment
@ Cassette Compartment
a
NS
cn
*“Dolby” and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
Noise reduction system manufactured under license
from Dolby Laboratories Licensing Corporation.
DISASSEMBLY INSTRUCTIONS
A.
How
to
remove
the
cassette
panel.
B.
How
to
remove
the
front
cabinet.
LE
@
‘|
©
ENS
1. Remove two screws-A. (1.7x4) and Fig. 2 Fig. 3
ia
eh
1.
Remove
two
screws-B.
(2x4)
2.
es
four
screws-C.
(1.74)
(Fig. 1), (Fig. 2) 3. Remove one screw-D. (2x10)
(Fig. 3)
C. How to remove the mechanism.
1. Pull off the plug-E (5p). (Fig. 5)
m When replacing the mechanism.
Push the reverse button to “REV”
position. (Fig. 5)
Front Cabinet
4. Remove the front cabinet in the
direction of arrow. (Fig. 4)
@ Note (How to replace the dial E. How to remove the circuit
chassis)
D. How to remove the Dial Dial Pointer
Chassis.
|
Dial
Chassis
: - 7
——— ll
Start Point Fig. 7
When replacing the dial chassis.
1. Turn the dial gear and tuning nob
(Dial Chassis) to counter-clock
wise.
2. Set the dial pointer to start point. 1. Remove the knob in the direction
1. Remove one screw-F. (2x8) (Fig. 6) (Fig. 7) of arrow. (Fig. 8)
— 2? —