23
A
3. HOW TO INSTALL THE OUTDOOR UNIT
3-1. Transporting
When transporting the unit, have it delivered as close to the
installation site as possible without unpacking.
Use a hook for suspending the unit respectively according to
the type of model.
Lifting belt
Protective cardboard
or cloth
Detailed drawing A
Fan guard
These are not lifting holes.
CAUTION
● When hoisting the outdoor unit, pass lifting belts through
the left and right holes of the bottom plate as shown in the
following figures. Use two lengths of lifting belt 7.5 meters
long or longer.
● Hang the lifting belt at an oblique angle of the four corners
of the bottom plate. If it is hung at other areas, the lifting belt
becomes loose and the outdoor unit will be damaged or you
may be injured.
● Pay high attention to the unit not to lose the balance when
lifting. Also, safety measures should be taken not to loosen
the belt when lifting the load.
● Use protective panels or padding at all locations where the
lifting belt contacts the outer casing or other parts to prevent
scratching. In particular, use protective material (such as
cloth or cardboard) to prevent the edges of the top panel
from being scratched.
00_341136_2WAY_Eng.indb 23 2022/9/19 9:27:22
To Next Page
Loading...
