Panasonic S-36PU1E5

6-9
6
• Setting mode 2
<Operating procedure>
(1) button, button, and button simultaneously for
4 seconds or longer.
(2)
and buttons to change the item
code. The item codes and setting data are shown in the table below.
(3)
and buttons to change the setting data.
To confirm the changed setting data, press the button.
(At this time, “Setting” stops blinking and remains lit.)
(4)
outdoor unit address “System XX-YY” (System XX = System address, YY =
Address at outdoor unit sub-bus), item code number (DN value in the table
below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig. A ) and the last 3
digits (Fig. B ). When the first 3 digits are displayed, the top point of the colon is lit.)
(5)
Press and hold the
Use the temperature setting
Use the timer time
During this mode, “Setting” is displayed, blinking. The display shows the set
To end the setting mode, press the
button. The display returns to the normal display mode.
(3)(1)
(2)
(5)
A
B
(3)
(1)
(2)
(5)
Display of first 3 digits
80: <Refrigerant type>
A
and
B
are displayed alternately. (Example shows 000 410 (R410A).)
Display of last 3 digits
List of Item Codes
ParameterItem code
80 407 = R407C 22 = R22 410 = R410A
81 0 = Disabled
56 = Type 50
71 = Type 60
80 = Type 71
112 = Type 100
140 = Type 125
160 = Type 140
224 = Type 200
280 = Type 250
82 Do not set
86 Do not set
87 Do not set
88 Do not set
89 Do not set
8A Do not set
8b Do not set
Do not set
83
84 0 = 3-phase 1 = single-phase
85 0 = Disabled 1 = 50Hz
8E
Upward fan
model only
available
Refigerant type
Outdoor unit capacity*
Control system schedule
Control system schedule
Control system schedule
Control system schedule
Control system schedule
Control system schedule
Control system schedule
Control system schedule
3-phase or single-phase
Power frequency
Control temp. for outdoor
fan's crack prevention
Setting temperature range : -125
~ +125
Crack prevention of outdoor fan actuates when the outdoor temp.
reaches lower than the setting values.
(*) Figures represent the capacity data for each model.
SM830211-02PAC-i.indb9SM830211-02PAC-i.indb9 2012/07/122:10:572012/07/122:10:57