0 : STOP, 1 : EJECT, 2 : REW 3 : FF, 4 : REV, 5 : CUE, 6 : SLOW 7 : POWER OFF, 8 : PLAY, 9 :
STILL, U : REC, A : REC PAUSE, - : ADUB, N : ADUB PAUSE, L : INSERT, NONE DISPLAYED :
INSERT PAUSE
<Meaning of Additional data, (Data 2), Tape position)
Type of tape Criterion of tape position between starting and end
terminals
T-90 or above (Thin
Hub)
Between starting terminal: L and end terminal: 1 with
fourteen levels of change
T-60 or below (Thick
Hub)
Between starting terminal: U and end terminal: 5 with sic
levels of change
<Data 2 display>
Thin Hub L n -- A u 9 8 7 6 5 4 3 2 1
Thick Hub U 9 8 7 6 5
*1 <Additional data, (Data 2)> (EJECT reason)
Data 2 Reason
1 Loading completed when no tape is loaded. (spinning)
2 S-photo, S-reel, or Cap system failure during down
short REW operation
3 Mechanism locking during loading
4 L both terminals detected when loading starts
*Additional data 3 and 4
While the self-diagnosis history is displayed, press the STOP button (on the unit or the remote
controller unit) to switch between Additional data 3 and 4.
23
To Next Page
Loading...
