12.3 DVD Self Diagnostic Function-Error Code
Player
buttons
Remote control
unit buttons
Application Note
STOP
0 Error code display
(Refer to the item, “12.3. DVD
Self Diagnostic Function-Error
Code ”).
5 Tilt adjustment
Refer to the item “15.4. Optical
adjustment”).
6 Area number and broadcasting system check
7 Built-in program version check
DISPLAY DVD laser drive current check
Refer to the item “12.1. Optical
Pickup Breakdown Diagnosis ”.
3 CD laser drive current check
PAUSE
Writing of laser drive current value after replacement of
optical pickup (Do use this function only when optical
pickup is replaced.)
10
Initialization of the player (factory setting is restored.)
Used after replacement of micro-computer and its
peripherals and printed circuit board.
Error
Code
Error Content Additional error explanation
U, H error
U11 Focus error
H01 Tray loading error
H02 Spindle servo error (Spindle servo, DSC (IC3001) SP motor, CLV servo error)
H03 Traverse servo error
H04 Tracking servo error
H05 Seek error
H06 Power error
Cannot switch off the power because of the panel and
system computer communication error
H07 Spindle motor drive error
DSC related
F500 DSC error
DSC (IC3001) stops in the occurrence of servo error (starup,
focus error, etc.)
F501 DSC not Ready
DSC-system computer communication error (Communication
failure caused by idling of DSC)
F502 DSC Time out error Similar disposal as F500
F503 DSC communication Failure
Communication error (result error occurred although
communication command was sent)
F504 Error adjusting DSC data slice offset
F505 DSC Attention error Similar disposal as F500
F506 Invalid media Disc is flipped over, TOC unreadable, incompatible disc
ODC related
F600
Access failure to management information
caused by demodulation error
Operation stopped because navigation data is not accessible
caused by the demodulation defect
F601 Indeterminate sector ID requested
Operation stopped caused by the request to access
abnormal ID data
F602
Access failure to LEAD-IN caused by
demodulation error
LEAD IN data unreadable
F603
Access failure to KEYDET caused by
demodulation error
Access failure to CSS data of disc
F610 ODC abnormality No permission for command execution
F611 6626 QCODE don’t read Error Access failure to seek address in CD series
F612 No CRC OK for a specific time Access failure to ID data in DVD series
F620 Laser safeguard: high temperature condition
F621 Laser safeguard: circuit failure condition
F630 No reply to KEY DET enquiry (for internal use only)
F631
CPPM KEY DET is not available till the FILE
terminal
(CPPM file system is unreadable caused by scratches)
F632 CPPM KEY DET is not available Been revoked or falsified
To Next Page
Loading...
