“ATTENTION SERVICER”
Some chassis components may have sharp edges. Be careful when
disassembling and servicing.
1. This section describes procedures for checking the operation of
the major printed circuit boards and replacing the main
components.
2. For reassembly after operation checks or replacement, reverse
the respective procedures.Special reassembly procedures are
described only when required.
3. Select items from the following index when checks or
replacement are required.
4. Refer the Parts No. on the page of "Main Component Replacement
Procedures", if necessary.
Contents
- Checking Procedure for each major P.C.B.
- Checking of the Main P.C.B. & Transformer P.C.B.
- Checking for the Deck P.C.B. , Headphone P.C.B. and Tape Eject
P.C.B.
- Checking for the Panel P.C.B. and Power P.C.B. and Speaker
Terminal P.C.B.
- Checking for the CD Servo P.C.B.
- Disassembly and Assembly of the Disc Tray and CD Traverse Unit
- Disassembly of the Disc Tray
- Disassembly of the CD Traverse Unit
- Main Component Replacement Procedure
- Replacement of the CD Servo P.C.B. and Optical Pick-up Unit
- Procedure for Replacing Cassette Holder
- Procedure for Replacing Pinch Roller and Head Block (Cassette
Mechanism Unit)
- Procedure for Replacing Motor, Capstan Belt A, Capstan Belt B
and Winding Belt (Cassette Mechanism Unit)
- Procedure for Replacing parts on Mechanism P.C.B.
Warning :-
This product uses a laser diode. Refer to caution statement
9
To Next Page
Loading...
