Panasonic SA-PM65MD - Checking Procedure for each major P.C.B.

1. This section describes procedures for checking the operation of
the major printed circuit boards and replacing the main
components.
2. For reassembly after operation checks or replacement, reverse
the respective procedures.Special reassembly procedures are
described only when required.
3. Select items from the following index when checks or
replacement are required.
4. Refer the Parts No. on the page of "Main Component Replacement
Procedures", if necessary.
Contents
- Checking Procedure for each major P.C.B.
- Checking for the Transformer P.C.B. and Main P.C.B.
- Checking for the Panel P.C.B., CD Loding P.C.B., MD Loding P.C.B.
and Tact Switch P.C.B.
- Checking for the MD Servo P.C.B. and MD Connector P.C.B.
- Checking for the CD Servo P.C.B.
- Checking for the Power P.C.B.
- Diaassembly and Assembly of the Disc Tray and CD Traverse Unit
- Disassembly of the Disc Tray
- Disassembly of the CD Traverse Unit
- Main Component Replacement Procedure
- Replacement of the CD Servo P.C.B. and Optical Pick-up Unit
- Removal of the Deck P.C.B. and Mechanism P.C.B. for replacing
parts
- Replacement for the Magnetic Head and Optical Pick-up
- Replacement for the Belt and Loading Motor Assembly
- Replacement for the Traverse Motor Assembly
Warning :-
This product uses a laser diode. Refer to caution statement
Precaution of Laser Diode.
ACHTUNG :-
- Die Lasereinheit nicht zerlegen.
- Die Lasereinheit darf nur gegen eine vom Hertsteller spezifizierte
13