- 42 -
Advanced operations
[BTT880] Front speaker, Surround speaker
Attach to a wall without the base and the stand.
≥ Reattaching the speaker cable to the stand
[BTT500W] Front speaker
[BTT500W] Surround speaker
Preventing tipping
[BTT8 80] Front speaker, Surround speaker
Preventing falling
Front speaker, Surround speaker, Centre speaker
1 Thread a string to the speaker.
≥ Use a string of less than ‰ 2.0 mm, which is
capable of supporting over 10 kg.
e.g., [BTT880] Front speaker
A String (not supplied)
B Rear of the speaker
2 Thread a string from the wall to the
speaker and tie tightly.
C Screw eye (not supplied)
D Wall or pillar
E Approx.150 mm
F Approx.120 mm
D 45 mm E 22 mm F 330 mm
G 45 mm H 25 mm
I 40 mm J 41 mm
Straighten the
cable and run
through the stand.
Pull out the cable
through the hole.
180 mm
To prevent tipping/falling of the
speakers
When mounted on a wall
When placed on the floor
To Next Page
Loading...
