Panasonic SC-HT80 - Speaker Setup Guide; Preparing Speakers; Speaker Placement and Connection

S p eaker set -up
«;• Refer also to “Speaker set-up”, a separate guide included with these operating instructions.
The 4 small cnoakpr<; arp thp «amp
Attach the stickers to the speaker cords.
® @; Attach stickers 1 to 4 to the cords of the 4 small speakers
(2 X front and 2 x surround: SB-AFC80).
(5) : Attach sticker 5 to the cord of the medium-sized speaker
(center speaker: SB-AFC285).
(6) : Attach sticker 6 to the cord of the iarge speaker
(subwoofer: SB-W80).
31 Position th6 speakers
21 Attach the rubbeHefet to thp
speaker
The four smail speakers and the medium speaker can be set-up
either standing or iying down. Attach these rubber feet to prevent
vibration causing the speakers to move or fall over.
©Center speaker
® Front speaker (left) ■ ' '* S.* ©Front speaker (right)
® - ® : Position the speakers as indicated in the diagram using
the stickers as a guide.
X- The front, center, and surround speakers shouid be piaced
at approximately the same distance from the listening
position. The angles in the diagram are approximate.
• Place the front left and right speakers (0, ©) either side of
the television.
• Place the center speaker (©) directly above the television.
• Place the surround speakers (©, 0) either side of the
listening position, or slightly to the rear, about 1 meter
(3 feet) higher than ear level.
• The subwoofer (®) can be placed anywhere as long as it is
not too far from the television.
fma
If you are unable to position the surround speakers as
recommended, you can put them near the front speakers and still
achieve a surround-like effect (^ “Virtual rear surround”, page 33).
4 I Connect the speakers to the unit
Speakers cords
• Connect the cords so the numbers on the stickers
match the numbers under the terminals.
• Connect the gray cords with the blue stripe 0 to
the blue terminals.
• Connect the gray cords without stripes 0 to the
gray terminals.
• Connect the subwoofer’s red cord to the red
terminal © and the black cord to the black
terminal 0.
• Ensure the wires of the cords are fully inserted so
they do not touch each other and short circuit.
© Gray (no line) or red
1223
After you have completed set-up and connection, wind the excess cord and keep together with string.
8
RQTS235