6
RQT8221
≥Attach the speaker-cable stickers to make connection easier.
≥The terminals of the subwoofer and the digital receiver have high output power. Carefully connect the speaker wires.
[Note]
≥Never short-circuit positive (i) and negative (j) speaker wires.
≥Be sure to connect only positive (copper) wires to positive (i) terminals and negative (silver) wires to negative (j) terminals. Incorrect
connection can damage the speakers.
≥Do not use more than one pair of surround speakers when using this wireless system.
STEP3
Connecting speakers with the subwoofer and the
digital receiver
Click!
Sheet of speaker-cable stickers
Speaker-cable sticker
2 FRONT (R)
1 FRONT (L)
5 CENTER
ACTIVE
SUBWOOFER
Insert the wire fully.
Click!
Speaker cable
(For center speaker)
Copper
Silver
AC mains lead
[Continental]Europe,]Southeast[Asia,]
[the[Middle[East,[South[Africa,]
[Saudi[Arabia[and[Kuwait]
Front and center speaker connection
Connect the surround speaker cables here only if you do
not intend to use the digital receiver (➜ below).
4 SURROUND (R), 3 SURROUND (L)
[Saudi[Arabia[and[Kuwait]
The illustration shows the model for Continental Europe.
AC IN~
.
4
VOLTVOLT
ADJADJ
110-110-
127V127V
220-220-
240V240V
Click!
i: Copper
j: Silver
≥Connect the AC mains lead after speaker cable connections are complete.
To household
mains socket
AC mains lead
DIGITAL
RECEIVER
4 SURROUND (R)
3 SURROUND (L)
Surround speaker connection
The illustration shows the model for Continental Europe.
[Southeast[Asia,[the[Middle[East,]
[South[Africa,[Saudi[Arabia]
[and[Kuwait]
Before connecting the
AC mains lead
Set the voltage.
Use a flat-head screwdriver to
turn the voltage selector on the
back of the receiver to the
appropriate position for the area
in which this system is used.
[Saudi[Arabia]and[Kuwait]
BE SURE TO READ THE CAUTION FOR THE AC
MAINS LEAD ON PAGE 3 BEFORE CONNECTION.
Connecting speakers with the subwoofer and the digital receiver
HT885W_En.book Page 6 Thursday, October 20, 2005 12:31 PM
To Next Page
Loading...
