8
RQT8221
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥heat or expose to flame.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
Remove if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 10), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
STEP5
The digital transmitter, radio and system connections
TV
AUDIO
IN
VCR
VCR
AUDIOAUDIO
ININ
FM ANTFM ANT
AM ANTAM ANT
(75(75≠
)
LOOPLOOP
EXTEXT
COMPONENT VIDEO OUTCOMPONENT VIDEO OUT
(PROGRESSIV(PROGRESSIVE/INE/INTERLACE)TERLACE)
P
B
Y
P
R
L
R
S-VIDEOS-VIDEO
OUTOUT
VIDEOVIDEO
OUTOUT
A
AUXAUX
DIGITAL
TRANSMITTER
1
2
VOLT ADJ
127 V 110 V 220 V-230 V 240 V
Active subwoofer
Adhesive tape
System cable
Catch up
To disconnect
Press the catch
and pull out.
To disconnect
Press the catch
and pull out.
AC mains
lead
Main unit
≥Connect the AC mains lead after all other connections are complete.
≥Optional antenna connections (➜ page 23).
The illustration shows the model for Continental Europe.
AM loop antenna
Stand the antenna up on its base.
Place the antenna where reception is best.
Keep loose antenna cable away from other
wires and cables.
Catch up
Click!
System cable
AM loop
antenna
FM indoor
antenna
FM indoor antenna
Affix this end of the antenna
where reception is best.
To household
mains socket
Conserving power
The main unit consumes a small amount of power, even when it is turned off
(For Continental Europe: approx. 0.7 W or for Southeast Asia, the Middle East,
South Africa, Saudi Arabia and Kuwait: approx. 0.9 W). To save power when the
unit is not to be used for a long time, unplug it from the household mains socket.
You will need to reset some memory items after plugging in the unit.
[Note]
The included AC mains lead is for use with this unit only. Do not use it with other equipment.
Digital
transmitter
Digital transmitter
Insert fully until you
hear a click.
Do not insert or remove
while the main unit is on.
AC mains lead
[Continental]Europe,]Southeast[Asia,[the[Middle[East,]
[South[Africa,[Saudi[Arabia[and[Kuwait]
[Saudi[Arabia[
[and[Kuwait]
[Southeast[Asia,[the[Middle[East,[
[South[Africa,[Saudi[Arabia[and[Kuwait]
Before connecting the AC mains lead
Set the voltage.
Use a flat-head screwdriver to turn the voltage selector
on the back of the subwoofer to the appropriate position
for the area in which this system is used.
If the power supply in your area is 115 V or 120 V,
please set the voltage selector as follows:
≥For 115 V: Set to 110 V.
≥For 120 V: Set to 127 V.
[Saudi[Arabia]and[Kuwait]
BE SURE TO READ THE CAUTION FOR
THE AC MAINS LEAD ON PAGE 3 BEFORE
CONNECTION.
≥Do not use
rechargeable type
batteries.
Remote control Batteries
Insert so the poles (i and j) match those in the
remote control.
The digital transmitter, radio and system connections/The remote control
HT885W_En.book Page 8 Thursday, October 20, 2005 12:31 PM
To Next Page
Loading...
