Panasonic SC-HTE80

14
RQT9860
 Main unit displays
“F61”
• There is a problem with the amplifier of the system.
• Disconnect the AC power supply cord and consult the
dealer.
“F70 HDMI”
• Check HDMI connection.
• Turn off the system and then turn it on again.
• Disconnect the HDMI cable.
“F76”
• There is a problem with the power supply.
• Disconnect the AC power supply cord and consult the
dealer.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1 While the system is turned on, press and hold
[1] on the main unit for a minimum of
4 seconds.
2 Release [1].
“RESET” is shown.
3 Turn off the system and then turn it on again.
All the settings are reset to the factory defaults.
Note:
The remote control code will set back to “REMOTE 1”
after memory reset, refer “Remote control code” on how
to change to “REMOTE 2”.
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
• Turn off all other Panasonic products.
• Turn on this system.
• Aim the remote control at the remote control sensor of
this system.
 To set the code to “REMOTE 2”
Press and hold [MUTE] and [OK] for a minimum of
4 seconds.
“REMOTE 2” is shown.
 To set the code to “REMOTE 1”
Press and hold [MUTE] and [T] for a minimum of
4 seconds.
“REMOTE 1” is shown.
Maintenance
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean
this system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
RQT9860-Y_en_us.fm Page 14 Monday, February 10, 2014 10:05 AM