Panasonic SC-HTX5

RQT9478
15
Checking speaker output
Check connections when the speaker does not output the test signal. (➜ page 5)
Note
Checking audio output with a test signal
Adjusting speaker (subwoofer, wireless surround speaker) output
Checking speaker output
Connection
1. Press to turn on the system.
2. Press to output the test signal.
Speaker display
L : Front left, R : Front right, SUBW : Subwoofer,
RS : Wireless surround right, LS : Wireless surround left
• The test signal is output from one speaker at a time for two seconds in the following order.
TEST L TEST R TEST SUBW
When using the wireless surround speakers (
➜
page 14)
• The test signal is output from one speaker at a time for two seconds in the following order.
TEST L p TEST R p TEST RS p TEST LS p TEST SUBW
3. Press to adjust the volumes of
front speakers to the normal listening level.
4. Press to stop the test signal.
Adjustment range:
0 (Min) to 50 (Max)
If you feel the output of subwoofer and surround speakers (only when connected ➜ page 14) is not balanced with
front speakers, adjust the speaker output according to your preference.
1. Output the test signal. (➜ above, steps 1 to 3)
2. Press to select a speaker for adjustment.
When not using the wireless surround speakers
SUBW (Subwoofer)
When using the wireless surround speakers (➜ page 14)
SUBW (Subwoofer) p RS (Wireless surround right) p LS (Wireless surround left)
3. Press to adjust each speaker’s output level.
• The test signal comes from the speaker being adjusted.
• The test signal is output again in the above order 2 seconds after adjustment.
 Repeat steps 2 and 3 to adjust the level of each speaker.
4. Press to stop the test signal.
Adjustment range:
SUBW: OFF, MIN, 1 to 19, MAX
RS, LS: –10 to +10
• The front speakers cannot be adjusted with this operation. To adjust the volume balance of left and right front speakers, see
“Adjusting the volume balance of front speakers”. (
➜
page 21)
• When you select “OFF ” for subwoofer adjustment, there is no output from the subwoofer.
• Even if you adjust each channel level in this adjustment, each channel level setting in each SFC mode (
➜
page 17) does not
change.
• When you make this adjustment, Dolby Virtual Speaker functions. When playing 2-channel sources, Dolby Pro Logic also works
in conjunction. (
➜
page 17)
• You can adjust the speaker level while playing movies and music. (
➜
page 20)
Note
Aim the remote control toward
the signal sensor (➜ page 6) on
the control panel of this system.