Panasonic SC-PM07

Recording
operations
(D-
TvT> , i, hi, taJM
||g||||||»
SI?
■ /-DEMO -
1
side to be recorded
facing up
Before recording
Types of tapes which can be recorded correctly
The system automatically identifies the type of tape.
NORMAL POSITION/TYPE 1 /
HIGH POSITION/TYPE II
X
METAL POSITION/TYPE IV
X
High position and metal position tapes can be used, but the
unit will not be able to record or erase them correctly.
a
Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
The effect of volume and sound quality on
recording.
These have no effect on recording.
They can be changed for playback.
To erase a recorded sound
©Press P/-DEMO] to select TAPE mode.
© Insert the cassette with the exposed tape facing left.
©Press [•REC/II],
1-
■
Your attention is drawn to the fact that recording pre-
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
Recording the radio
• REC/II
r- n
J ..V • ' -> '
-». ■ _/ --J.
J i. ^ J
J -«* ■ '
I
I
■ FM MODE/BP
Preparation:
• Wind on the leader tape.
• To record from halfway through the tape
Wind the tape on to where you want to start recording.
• Press [C/I] to turn the unit on.
1 Insert the tape to be recorded on.
Insert with the exposed tape facing left.
2 Tune to the required station.
page 10 or 11)
3 Press [#REC/II] to start recording.
To stop recording
Press P/-DEMO].
To stop recording temporarily
Press [• REC/II].
To resume recording, press [•REC/II],
□ To reduce noise while recording an AM broadcast
(Beat proof function)
by remote control only
Press [FM MODE/BP] while recording.
Every time you press the button:
bP 1 <-> bP 2
Select the position where there is less noise.
RQT6096