Before use
8
RQT5243
30˚ 30˚
OPEN/CLOSE
C
B
A
Concerning the remote control
Battery installation
A
Use of batteries
³Do not mix old and new batteries, or batteries of different types
(manganese and alkaline, etc.).
³Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
³If the remote control is not to be used for a long period of time, re-
move the batteries and store them in a cool, dark place.
³Do not attempt to recharge alkaline or manganese batteries.
³Do not use rechargeable type batteries.
Correct method of use
B
Operations notes
³Do not place obstacles between the remote control signal sensor
and remote control unit.
³Do not expose the remote control signal sensor to direct sunlight or
to the bright light of a fluorescent light.
³Take care to keep the remote control signal sensor and end of the
remote control unit free from dust.
³If this system is installed in a rack with glass doors, the glass doors’
thickness or color might make it necessary to use the remote con-
trol a shorter distance from the system.
To prevent damage
³Do not place heavy items on the remote control.
³Do not disassemble or reconstruct.
³Do not spill water or other liquids on the remote control.
Opening/closing the glide panel C
When the unit is turned on, the glide panel retracts automatically ena-
bling access to the operation buttons.
When the unit is turned off, the glide panel closes automatically.
To open/close the glide panel manually
Press [OPEN/CLOSE] when the unit is on.
When the glide panel is closed manually, the display light dims.
Transmission window
Insert the batteries observing the
correct polarities (+, -).
Remote control signal
sensor
R6, AA, UM-3
About 7 meters in front
of the signal sensor
1-23e.p65 11/9/99, 4:34 PM8
To Next Page
Loading...
