RQTV0303
14
Using other equipment (continued)
Compatible devices
Devices which are defi ned as USB mass storage class:
• USB devices that support bulk only transfer.
• USB devices that support USB 2.0 full speed.
Supported Format
Files must have the extension “.mp3” or “.MP3”.
Note
• CBI (Control/Bulk/Interrupt) is not supported.
• A device using NTFS fi le system is not supported [Only FAT
12/16/32 (File Allocation Table 12/16/32) fi le system is supported].
• Depending on the sector size, some fi les may not work.
• This unit can access up to 255 albums (including blank folders) and
2500 tracks.
• The maximum number of tracks in a folder are 999 tracks.
• Only one memory card will be selected when connecting a multiport
USB card reader. Typically the fi rst memory card inserted.
• Do not unplug the USB device during reading or playback.
•
Disconnect the USB card reader from the unit when you remove the
memory card. Failure to do so may cause malfunction to the device.
• When you connect a compatible digital audio player to the USB
port, charging maybe activated. It will not charge when the unit is
switch to standby mode.
portable audio equipment
This feature enables you to enjoy music from portable audio
equipment.
Audio cord (not included)
Portable audio
equipment
(not included)
MUSIC P.
Switch off the equalizer function (if there is any) of the portable audio
equipment before you plug into the MUSIC PORT jack. Otherwise,
sound from the speaker may be distorted.
1
Plug the audio cord into the MUSIC PORT jack and press
[MUSIC PORT].
2
Play the portable audio equipment. (See the portable audio
equipment’s instruction manual.)
Note
All peripheral components and cables are sold separately.
Changing the remote control code
Changing the remote control code
Change the code if you fi nd the remote control unintentionally also
controls other equipments.
Change the main unit’s code
Change the main unit’s code
Press and hold [MUSIC P.] on the main unit and then press and
hold [2] (or [1]) on the remote control.
“REMOTE 2” is displayed.
Change the remote control’s code
Change the remote control’s code
Press and hold [ENTER] and [2] (or [1]) on the remote control for
at least 2 seconds.
If the remote control and main unit are using different codes, a
message appears on the main unit’s display showing the main unit’s
current code. Follow the above step to change the remote control’s
code to match it.
Maintenance
If the surfaces are dirty
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
PM46_EB_En_new9.indd 14PM46_EB_En_new9.indd 14 1/10/08 10:29:59 AM1/10/08 10:29:59 AM
To Next Page
Loading...
Need help?
General
