Making the connections
Connect the AC mains lead only after all other connections have been made.
Simple setup
Connect the DAB “T” antenna
The cross bar of the T should be kept fi rmly stretched.
Find a position with good reception.
There is a function on the unit to check signal quality.
For best reception
A DAB outdoor antenna is recommended (➡ page 5).
Be sure to fully
tighten the screw.
Adhesive tape
Connect the FM indoor
antenna.
Tape the antenna to a wall or column,
in a position with least amount of
interference.
Adhesive
tape
FM indoor
antenna
Connect the AC mains lead.
READ THE CAUTION FOR THE AC MAINS LEAD
ON PAGE 2 BEFORE CONNECTION.
The included AC mains lead is for use with this unit only.
Do not use it with other equipment.
Insertion of connector
Even when the connector is perfectly inserted,
depending on the type of inlet used, the front part of
the connector may jut out as shown in the drawing.
However there is no problem using the unit.
Connector
Appliance inlet
Connect the speaker cables.
Red (ª)
Black (·)
Black (·)
Incorrect connection can damage the unit.
Red (ª)
PM46_EB_En_new9.indd 4PM46_EB_En_new9.indd 4 1/10/08 10:29:44 AM1/10/08 10:29:44 AM
To Next Page
Loading...
