3
VQT4X47
Supplied accessories
Check and identify the supplied accessories.
Maintenance
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean
this system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Point the remote control at the remote control sensor,
away from obstacles, at a maximum range of 7 m
directly in front of the main unit.
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
1 Connect the DAB antenna.
Place the antenna where reception is best.
• Use DAB outdoor antenna (not supplied) for better
reception.
2 Connect the speakers.
Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so may
damage the speakers.
3 Connect the AC mains lead.
Do not use an AC mains lead with other equipment.
Conserving power
The system consumes approximately 0.4 W when it is in
standby mode. Disconnect the power supply if you do
not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
You can connect a VCR, DVD player etc.
Note:
• Disconnect the AC mains lead before connection.
• Switch off all equipment and read the appropriate operating
instructions.
• Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adaptor.
1 x AC mains lead
(K2CT2YY00097)
1 x Remote control
(N2QAYB000896)
1 x DAB antenna
(N1EADY000001)
1 x Remote control
battery
2 x Speaker cables
(RFAV0074A-1)
To Next Page
Loading...
