14
RQT0A76
Recording a CD to the
internal memory
You can record a CD to this unit’s internal memory.
The recordings will be stored under your selected
number for (FAVOURITE) [1] to [5].
The CD recording duration is the same as its playback
duration in order to record in high quality. Enjoy the
playback while recording.
≥ Supported recording source:
A disc with CD audio in CD-DA format
≥ This unit is pre-recorded with a sample music under
each (FAVOURITE) [1] to [5]. Overwrite the
pre-recorded content when “TO OVERWRITE,
PRESS REC” is displayed during the recording
procedure. (l right)
– You can also delete the content before recording. (l 15,
“Deleting the internal memory contents ([MEMORY])”)
Preparation
≥ Turn the unit on.
≥ Load a disc.
≥ Press [CD/ ] repeatedly to select "CD".
≥ Select the recording mode. (l below)
≥ You cannot check the remaining capacity in the internal
memory.
≥ When recording starts, the playback mode and programme
settings will be cleared.
≥ During recording, only limited operation controls are
available, such as volume adjustment, stop recording,
turning the unit off.
You can choose from 2 recording modes.
Press [REC MODE] repeatedly to select the desired
recording mode.
≥ The factory default is "HQ 1-CD".
≥ You cannot record by two types of recording mode within
each (FAVOURITE) [1] to [5].
1 Press [¥ REC] in the stop mode.
≥ “SELECT NUMBER” is displayed.
2 Press one of [1] to [5] for storing your recording.
∫ If there is recorded content under the
selected number
≥ “TO OVERWRITE, PRESS REC” is indicated
on the display.
– To overwrite the recorded contents, press
[¥ REC] to proceed recording.
– To cancel, press [∫].
∫ If there is no recorded content under the
selected number
≥ Recording will start.
≥ When recording starts, the [¥ REC] indicator on
this unit will light up in red.
To check recording has finished
When recording ends, “WRITING” blinks on the display
for a few seconds. Then, the [¥ REC] indicator on this
unit goes off.
To stop recording
Press [∫].
≥ The recording will stop at the position [∫] is pressed.
1 Press [¥ REC] in the stop mode.
≥ “SELECT NUMBER” is displayed.
2 Press one of [1] to [5] for storing your recording.
≥ When recording the subsequent CD of the disc album,
select same number as your first recorded CD.
∫ When recording the first CD
If there is recorded content under the
selected number:
≥ To overwrite the recorded contents, press
[3, 4] to select “TO OVERWRITE, PRESS
REC” and then press [¥ REC] to proceed
recording.
≥ To cancel, press [∫].
If there is no recorded content under the
selected number:
≥ Recording will start.
∫ When recording the subsequent CD
≥ “TO ADD SONGS, PRESS REC” is indicated
on the display.
– To add the current recording under the
selected numeric button, press [¥ REC].
– To cancel, press [∫].
≥ When recording starts, the [¥ REC] indicator on
this unit will light up in red.
Do not disconnect the AC mains lead while
recording.
Selecting the recording mode
“HQ 1-CD”
mode
For normal CD recording in high
quality sound. You can record 1 CD
under each (FAVOURITE) [1] to [5].
“MULTI-CD”
mode
For recording a disc album consisting
of several CDs. You can record up to 5
CDs under each (FAVOURITE) [1] to
[5] (depending on the CD playback
duration).
Normal CD recording in high quality
sound (“HQ 1-CD” mode)
Recording a disc album consisting
of several CDs (“MULTI-CD” mode)
SC-RS52_EGEBGN_RQT0A76-B.book 14 ページ ２０１６年２月１９日 金曜日 午前８時５９分
To Next Page
Loading...
