Panasonic SF4B Series

27 © Panasonic Industrial Devices SUNX Co., Ltd. 2016
Function Setting
3-3-2 Floating Blanking Function
FLO1 <Effective setting of beam channel>
0: Ineffective
1: 1 beam channel setting
2: 2 beam channels setting
3: 3 beam channels setting
FLO2 <Ineffective setting of both end beam channel>
6(7(IIHFWLYH %RWKHQGVRIWKHEHDPFKDQQHOVDUHQRWVXEMHFWWRWKHÀRDWEODQNLQJIXQFWLRQ
&/5,QHIIHFWLYH$OOEHDPFKDQQHOVDUHVXEMHFWWRWKHÀRDWLQJEODQNLQJIXQFWLRQ
FLO3 <Non serial beam channel setting>
SET (Effective) : Non-serial beam channel mode
CLR (Ineffective) : Serial beam channel mode
Note: When “all sensors” is selected in the sensor selection, the setting of the floating blanking function on each SF4B /
SF4B<V2> series should be identical.
(Sub sensor 2)
Sensor selection
(All sensors)
(Main sensor)
(Sub sensor 1)
Set No. of beam channel
(Ineffective)
Input
password
Send
(Error)
To 2
OK
NG
To 2
Send
(Error)
OK
NG
(Ineffctive)
(Effctive)
(Ineffctive)
(Effctive)
Ineffective setting
for both ends
beam channels
Setting for non-
serial beam
channel
One beam
channel effecive
Two beam
channel effecive
Three beam
channel effecive
3. To Auxiliary
output switching
function
2. Floating blank-
ing function
key operation
: FUNCTION
: ENTER
: CANCEL
: -
: +
Ramco Innovations
(
800
)
280-6933 www.PanasonicSensors.com