Panasonic SF4B Series

30© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Function Setting
3-3-5 Copy Function
“****” indicates the connection state
of the system.
Ɣ “
”: SF4B / SF4B<V2> se-
ries is used only.
Ɣ “
”: SF-C14EX is used in
combination.
*1: The setting of the relay monitor
is as follows.
When set to ineffective: CLR
When set to effective: Set time
(100 to 600ms, in units of 10ms)
*2: The override function can be set
in the range of 60 to 600 sec. (in
units of 10 sec.)
Notes: 1) The indication is on the main sensor
(CH1) only.
2) When using in combination with
SF-C14EX, it is not indicated.
key operation
: FUNCTION
: ENTER
: CANCEL
: -
: +
(Override)*2
(Note 1, 2)
(Note 1)
Muting sensor
output operation
setting
Muting lamp
diagnosis
function setting
5. Copy function
Select function
(Upload)
(Download)
(Monitor)
Select sensor
Input
password
Check function
6. To Muting setting
changing function
(Error)
To 5
OK
NG
Receive
(Error)
To 5
OK
NG
Receive
Confirm function
of system device
Select item
(Note 1)
(Note 1)
(Note 2)
(Note 1)
(Note 2)
(Note 1)
(Note 2)
Detail display
(Only for SET)
(Effective)
(Ineffective)
࡮࡮࡮
Keep pressing switch OK
Detail display
(Only for SET)
(Effective)
(Ineffective)
࡮࡮࡮
Keep pressing switch OK
Detail display
(Only for SET)
(Set beam channels)
Both ends beam
channel ineffec-
tive setting
Non-serial
beam channel
setting
(Emission intensity control)
(Input mode)
(Interlock)
(Relay monitor) *1
(Protection)
(Auxiliary output)
Fixed blanking effective
/ ineffective display
Floating blanking effective
/ ineffective display


Ramco Innovations
(
800
)
280-6933 www.PanasonicSensors.com