4. Apply a crosshatch pattern signal and adjust the static convergence magnets to the approximately
correct position.
5. Receive a black and white signal.
6. Set the control as follows:
Red................minimum
Green.............minimum
Blue...............minimum
Press the Shipping button on the remote control twice to select CRT Adjustment Mode to select
low light.
7. Loosen the clamp screw for the Deflection Yoke A in Fig. 10 and move the Deflection Yoke as
close to the purity magnet as possible.
8. Adjust the purity magnetic rings so that a vertical green field is obtained at the centre of the
screen.
Fig. 6
9. Slowly push the Deflection Yoke and set it where a uniform green field is obtained.
Fig. 21
10. Re-adjust the Low Light controls to their correct settings and make sure that a uniform white
field is obtained.
11. Tighten the clamp screw A in Fig. 10.
http://202.224.189.179/viewing/OT/TC-14Z88RQ/SVC/s0207000000.html (2 of 5)10.02.2006 2:30:15
To Next Page
Loading...
