Convergence
1. Apply a crosshatch pattern signal and Normalize Contrast control to the maximum positions.
2. Adjust Brightness until the grey position of the crosshatch pattern just becomes black.
3. Adjust the Red and Blue line at the centre of the screen by rotating the R-B static.
Fig. 8
4. Adjust Red and Blue with Green line at centre of the screen by rotating (RB)-G static
convergence magnetic rings.
5. Lock convergence magnets with silicone sealer.
6. Remove the DY wedges and slightly tilt the Deflection Yoke vertically and horizontally to obtain
the good overall convergence.
Fig. 9
http://202.224.189.179/viewing/OT/TC-14Z88RQ/SVC/s0207000000.html (3 of 5)10.02.2006 2:30:15
To Next Page
Loading...
