2.2. Factory Mode Adjustment
How to set :
To set the Factory mode, press Volume 0 dac on the TV and Timer
Setting 30 min. on the remote control and press Volume (-) Down
button on the TV together press recall on the remote control. /
CHK should appear on right of TV screen. / To move from CHK1 to
CHK2 mode, etc. please follow below rotation :
To Set Self-Check :
Press the Volume Down button on TV then press the Off Timer
button on remote control.
2.3. Adjustment for White Balance
Preparation:
1. Receive the white balance pattern and aging should have been
performed over 30 minutes.
2. Set the picture menu to DYNAMIC NORMAL.
3. Degausse the CRT face.
4. Fix the CRT colour analyzer receiver unit to CRT face.
Adjustment of Low Light.
1. Adjustment Sub Bright, so that Y = 7.0 ± 1.0 nit.
2. Adjustment R-CUT OFF, so that X = 0.245 ± 0.010 nit.
5
To Next Page
Loading...
