TC-L42E5
30
7.18. Back Cover Preparation
1. Remove the barrier tape protector.
2. Insert the barrier into the grooves on the back cover (indicated by the letter “A”).
3. Stick the adhesive area (indicated by the letter “B”) on both bottom parts of the back cover.
4. Stick the felts on the bottom part of the back cover, see detail B for both at the sides of the bottom part of the back cover.
5. Stick the felts on the side part of the back cover, see detail C on both sides of the back cover.
6. Stick the felt at the top of the back cover, see detail D.
Note: The side felts are placed on both sides of the back cover.
No. Part Num. Quant. Description
1 TXFKU1112SER 1 ASSY, BACK COVER
2 TMK2AX235 1 BARRIER P PCB BC
3 TMK2AA183 2 FELT (0.55 × 10 × 330)
4 TMK2AA174 2 FELT (18*576*0.9)
5 TMK2AA173 1 FELT (18*975*0.9)
To Next Page
Loading...
