20
8.3. Picture level adjustment (RF)
8.4. Picture level adjustment (VIDEO)
8.5. Picture level adjustment (YUV)
Instrument Name Remarks
1. REMOTE TRANSMITTER
2. Ex. Signal (Split color bar)
Adjustment or Inspection Procedure Remarks
<procedure>
1. Receive the split color bar.
(Screen mode: ZOOM or FULL Picture mode: DYNAMIC AI: OFF AI Picture: OFF)
*BACK LIGHT +30
<Inspection>
1. Enter Service mode, and select MAIN_ADJ PICTURE.
Volume UP/DOWN key makes GAIN displayed under PICTURE to set.
Pushing the remote controller [OK] key for about 3 seconds, GAIN is suited
to the adjustment value automatically.
Instrument Name Remarks
1. REMOTE TRANSMITTER
2. Video signal generator (100% Color bar)
Adjustment or Inspection Procedure Remarks
<procedure>
1. Receive 100% color bar.
(ASPECT: ZOOM or FULL , Picture mode: VIVID , AI Picture: OFF)
*BACK LIGHT MAX VALUE
<Inspection>
1. Enter Factory adjustment mode, and select ADJUST CONTRAST.
Volume UP/DOWN key makes GAIN value displayed on the right of CONTRAST to set.
Pushing the remote controller [OK] key for about 3 seconds, GAIN is suited to the adjustment value auto-
matically.
Instrument Name Remarks
1. REMOTE TRANSMITTER
2. Component Video signal generator (100% Color bar 1080i)
Adjustment or Inspection Procedure Remarks
<procedure>
1. Receive 100% color bar.
(ASPECT: ZOOM or FULL , Picture mode: VIVID , AI Picture: OFF)
*BACK LIGHT MAX VALUE
<Inspection>
1. Enter Factory adjustment mode, and select ADJUST CONTRAST.
Volume UP/DOWN key makes GAIN value displayed on the right of CONTRAST to set.
Pushing the remote controller [OK] key for about 3 seconds, GAIN is suited to the adjustment value auto-
matically.
To Next Page
Loading...
