Panasonic Technics SL-1300

4 PLACEMENT
©
Use
the
player
in
a
stable
and
horizontal
position,
where
there
Is
little or no vibration.
@ Use the player as far away from the speakers as possible and
isolate the player from sound radiation from them.
This player is equipped with audio-insulators and designed for
the utmost absorption of vibration.
I the speakers are placed too near the player, sound vibration
may be transmitted to the tonerarm and result in “HOWLING
Place the player as far away from the speakers as possible.
© Do not place the player where it is exposed to direct sun, dust
or moisture.
Also keep away from heating equipment in order to protect the
dust cover.
5 CONNECTIONS
CONNECT TO THE AC POWER
SOCKET
Connect the AC power plug to the AC socket of 120V.
This set is designed to be used at AC 120V.
Never connect to the DC power socket or other voltage socket
I you connect the power plug to the AC outlet such as amplifiers
have, confirm the voltage and wattage of rating at the outlet
CONNECT TO THE AMPLIFIER
Connect
the
output
terminals
to
the
same
channels
of
the
ampli-
fier
OUTPUT TERMINALS AMPLIFIER
R (U-shaped) — EMM Channel
L (White) == —— [EEE Channel
E (U-shaped) — NT}
NOTE
Be sure to connect the ground terminal to the ampli
chassis,
Mf this connection is incomplete, a power source "HUM" will
result,
6 OPERATION
AUTOMATIC PLAYING
Release the arm clamp, so that the tonearm becomes free from
the arm rest.
Set the MEMO-REPEAT knob to the “0” position.
“R” position is continuous repeat play.
Set the record size selector to the diameter of the record you
wish to play.
Set the speed selector in the same manner as for record size
selector.
Pull the start/stop lever to the start position, then playing will
start automatically. (See Fig. 7)
When playing has finished, the tonearm will return to its rest
and the unit will shut off automatically.
jer or to the
MEMO-REPEAT knob
Start/stop
lever
Fig. 7
MANUAL PLAYING
Release
the
arm
clamp
and
raise
the
cueing
lever.
(See
Fig.
8)
Place
the
tonearm
over
the
lead-in
groove,
causing
the
turntable
platter
to
rotate.
Lower the cueing lever, then the tonearm will descend to the
record surtace slowly and playing will begin.
When
playing
has
finished,
the
tonearm
will
return
to
its
rest
and
the
unit
will
shut
off
automatically
Of course, it is possible to return the tonearm to its arm rest
‘manually, then the unit will shut off automatically.
5-10 mm (3/16”-25/64") Cueing lever
Cueing lever
(Descend)
Fig. 8
TO
INTERRUPT
PLAYING
Raise
the
cueing
lever,
then
the
tonearm
will
ascend
and
inter-
rupt playing.
It
you
lower
the
cueing
lever,
the
tonearm
will
descend
slowly
on
the
record
and
resume
playing
in
the
same
groove.