14 15
Viewing
Watching Videos and DVDs
TV operation
TV operation
or
Turn the TV On with the POWER button
(TV)
or
(Remote)
Input select: press (p. 15)
Select a channel number
up
down
or
(Remote)
To directly enter the digital
channel number
When tuning to a digital channel,
press the button to enter the
minor number in a compound
channel number.
example: CH15-1:
(TV)
Note
Reselect “Cable” or “Antenna” in “ANT in” of “ANT/Cable setup” to switch the signal
reception between cable TV and antenna. (p. 25)
The channel number and volume level remain the same even after the TV is turned
off.
Listen
with SAP
(Secondary
Audio
Program)
Select Audio mode for watching TV
Digital mode
Press SAP to select next audio track (if available) when receiving a digital channel.
Audio track 1 of 2
(English)
Analog mode
Press SAP to select the desired audio mode.
• Each press of SAP will change the audio mode. (Stereo/SAP/Mono)
Closed
caption
Switches the Closed caption mode On or Off
Closed caption Off Closed caption On muteClosed caption On
Information
recall
Displays or removes the channel banner
15-2
30
CC SAP
TV-G 1080i 4:3
ABC-HD
Channel
Station
identifier
Closed
caption
SAP
indication
Rating
level
Signal
resolution
Aspect ratio
Sleep timer
remaining time
Change
aspect
ratio
Press FORMAT to cycle through the aspect modes (p. 30)
• 480i, 480p: FULL/JUST/4:3/ZOOM
• 1080p, 1080i, 720p: FULL/H-FILL/JUST/4:3/ZOOM
Connections (p. 10-12)
Other Useful Functions (Operate after )
If you have applicable equipment connected to the TV, you can watch videos and DVDs on the TV screen.
Input Select
You can select the external equipment to access.
To return to TV
With the connected equipment turned On
Display the Input select menu
Select the input mode
Input select
TV
1
5
2
3
4
6
7
8
Component
HDMI 1
HDMI 2
HDMI 3
Video 1
PC
Video 2
AUX
DVD
(example)
or
select
enter
Press the corresponding NUMBER
button on the remote control to
select the input of your choice.
Select the input of your choice,
then press OK.
During the selection, if no action
is taken for several seconds, the
“Input select” menu disappears.
HDMI 1
DVD
Terminal
(example)
Label
The terminal and label of the
connected equipment are
displayed.
To label each of the inputs,
please refer to p. 27.
Note
The input label will be displayed on the “Input select” screen if the Input label is set
on p. 27.
For more details on “Input labels”, refer to p. 27.
Operate the connected equipment using the remote
control supplied with the equipment
Note
For details, see the manual for the connected equipment.
Watching Videos and DVDs
To Next Page
Loading...
