11.3. Sub bright adjustment
Instrument Name Connection Remarks
1. PAL signal generator (or RF) Connect to the input terminal User setting: Normal
Procedure Remarks
·
Color balance adjustment is finished for each signal.
·
Do adjustments in a dark room.
·
Complete the adjustment within 10 minutes after the turn on electricity.
Turn on the power supply again when it is not possible to complete it by aging etc.
1. Display the pattern for adjusting subbright from video input.
2. Use "Sub-Bright" in the <Sevice-Menu1> mode to adjust so the 6th section shows up and
the 7th fades away.
Data
Sub-Bright total 12bit data addresses
LSB 8bit A0-016c bit7-0
MSB 4bit A0-016d bit3-0
Picture menu: Dynamic
Color balance: Normal
ASPECT: 16:9
* If using RF ch.E04 or E43
40
TH-37PV60E / TH-37PX60B / TH-42PV60E / TH-42PX60B
To Next Page
Loading...
