22
Adjusting Pos./Size
H-Pos Adjust the horizontal position. V-Pos Adjust the vertical position.
H-Size Adjust the horizontal size. V-Size Adjust the vertical size.
Clock
Phase
(During PC input signal)
Eliminate the ickering and distortion.
Dot Clock (During PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,
adjust so that any such noise is minimized.
Over scan Turn image over scan On/Off.
Con gurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (DVI, HDMI)
On Off
Notes:
• “Off” is effective during only “16:9” aspect mode.
• When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.
1:1 Pixel
Mode
Adjusts the display size when 1125i or 1125p signal is input.
Notes:
• “On” is effective during only “16:9” aspect mode.
• Select On when you would like to replay 1920 × 1080 input signal.
• Applicable input signal;
1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p
• Select Off when ickering is shown around the image.
• H-Size and V-Size cannot be adjusted when On is selected.
Off On
While the Pos. / Size display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button is
pressed during “Normalise”, then all adjustment values (except “Clock Phase” and “Dot Clock”) are returned to the factory settings.
Helpful Hint ( /
Normalise
Normalisation)
To Next Page
Loading...
