22
TH-47LFT30W
8.3. Preparation
Please pull soft cloth etc. not to damage a screen and please
turn the front of a main part down and lay it down.
The cautions at the time of each module exchange
• When you exchange each module, please be sure to carry
out according to the following procedure.
• When you attach each module, please do not bolt a screw
strongly.
8.4. Removing the metal wall hang-
ing fittings
Undo sixteen screws (SPECIAL SCREW 5X12) to remove the
metal wall hanging fittings.
8.5. Disassembling the metal wall
hanging fittings
1. Undo four screws (SPECIAL SCREW 5X12) to remove
the metal wall hanging fittings.
2. When replacing the mounting frame, put four screws
(SPECIAL SCREW 5X12) in place.
8.6. Removing the AV covers
1. Undo the twelve screws to remove the AV cover from the
back plate. (SPECIAL SCREW 4X12)
2. Remove the AV cover and fit the replacement AV cover.
Precautions for removing and fitting the AV cover
• A specialty washer is fitted in one place on the AV cover to
ensure dustproof and waterproof performance. When fitting
the AV cover, always put the specialty washer on the screw
facing the correct direction (rubber side facing the AV cover).
• When removing the AV cover, undo all 12 screws in order
from the bottom up to prevent the AV cover from slipping off.
Beware of opening the AV cover with any screws left on as
this will damage the AV cover.
To Next Page
Loading...
