24
TH-47LFT30W
2. Undo the screws shown in the drawing, which hold the
back plate.
• A: SPECIAL SCREW 4X12, 20
• B: SPECIAL SCREW 5X12, 8
3. Lift the handle to remove the back plate.
8.10. Arrangement of the board
Remove the back plate to check the board.
8.11. Removing the cabinet front
(including the touch screen)
About cabinet front (touch panel is included) exchange
• After exchanging a cabinet front (a touch panel is included),
a setup of a touch panel is required.
Please refer to [9.1. a setup of a touch panel] for the setting
method.
1. Remove 17 screws which hold the cabinet front and cabi-
net back together. (SPECIAL SCREW 4X12)
2. Remove the touch screen control board holder. Remove
two screws which secure the holder. (SCR BIN+SW+W
3X6)
3. Remove the FFC cable and USB cable from the touch
screen control board.
To Next Page
Loading...
